SPS

Tools and Supplies: You will need two 10mm sockets (one long and one short), a ratchet (preferably 1/4in drive since its smaller and more maneuverable), a flat head screwdriver, and an extension for the ratchet (2 or 3-inch will do). (If you have a Saturn custom bra, then you will also need a 7mm socket and a Phillips head screwdriver.)

The Procedure:

1. Using the flathead screwdriver, loosen and remove the fasteners at the front end of the wheel-well fender liner. This will allow access to the rear bolt on the corner lamp. (You will need the Phillips screwdriver, 7mm socket, and the flathead if you have a Saturn custom bra.)
2. Open the hood and place headlights in the ‘up’ position with lights off.
3. Loosen all the quarter panel bolts along the inside ledge and remove the first three (so that you can get the lamp out).
4. Using the ratchet and long socket, reach beneath the front end along the quarter panel and remove the front bolt from the lamp being removed.
5. Using the ratchet w/extension and short socket, reach through the fender liner and remove the rear bolt of the lamp being removed.
6. Being careful not to bend the quarter panel, lift upward on the inside front end of the quarter panel and jiggle the lamp free of its housing.
7. Pull the old lamp out from the quarter panel – being careful not to break any wires.
8. Twist and pull out the bulbs from the old lamp and install the bulbs into the new clear corner lamp.
9. Install new corner lamp using reverse order of this procedure.
10. Tighten all removed bolts.